Pigs cannot sweat effectively, so hot weather quickly cuts feed intake, growth and fertility, and in extreme cases kills. Evaporative cooling is the main tool, and two common approaches are drip systems that wet the pig's back and misting or fogging systems that cool air or skin. Each has strengths and pitfalls related to humidity, water use and floor wetness. This article compares them, explains sizing and controls, and gives a practical decision guide.
Why evaporative cooling works
When water evaporates from a pig's skin, it removes heat. Because pigs have few functional sweat glands, they rely on wallowing, wetted skin and panting. Providing water that wets the skin gives them an alternative to a wallow. Evaporation works best when air is relatively dry and moving, and works poorly in very humid air.
Evaporative cooling raises barn humidity, so it needs a balance with ventilation. The main aim is to maintain comfortable body temperature without wetting bedding and floors excessively. Review Heat Stress in Pigs: Signs, Prevention and Cooling Methods and Heat Stress and Disease Susceptibility: Summer Protocols to understand the consequences of leaving heat unaddressed.
Drip cooling
Drip systems deliver water droplets onto the pig's neck and shoulders at intervals, using low-flow drippers placed over the lying area. The skin gets wet, evaporates and cools, with little water in the air. Drip systems suit finishing and sow barns, especially with tunnel ventilation providing air movement.
Advantages include relatively low humidity impact, modest water use and simple hardware. Drawbacks include clogging, uneven coverage and wet floors if drip is run too often. Pigs should be on slatted or sloped floors where water drains. Place drippers over the shoulder area where pigs lie, not over the dunging area.
Misting and fogging
Misting nozzles produce fine droplets that cool the air and wet pigs. Fog systems use even finer droplets and evaporate quickly, cooling air with less wetting. Misters are common in outdoor lots and open-sided buildings, where the air is dry and air movement is good.
Risks include high humidity in confined barns, which can reduce cooling and raise heat load. Mist can also wet bedding, create mold and increase ammonia if manure stays wet. Nozzles clog with minerals, so water quality and filtration matter, see Water Quality for Pigs: Mineral and Microbial Standards. Use timers and humidity limits.
Comparing the systems
| Feature | Drip | Misting or fogging |
|---|---|---|
| Wets the pig directly | Yes, at back and shoulders | Yes, with larger droplets |
| Humidity effect | Low to moderate | Moderate to high |
| Best climate | Humid or dry | Dry, with airflow |
| Water use | Lower | Higher |
| Floor wetness | Localized | Broader |
| Maintenance | Dripper clogging | Nozzle clogging, filters |
| Best building | Tunnel-ventilated, slatted | Open-sided, outdoor, well ventilated |
Neither system replaces ventilation. Combine either with enough air speed over pigs, which boosts evaporation and convective cooling, as in Swine Barn Ventilation: Air, Temperature and Humidity Basics.
Sizing and control
Follow manufacturer and extension guidance for flow rates and nozzle spacing. Typical practice uses cycle timers, with short wet periods followed by dry periods that allow evaporation. Controls can respond to barn temperature, starting at a set point and adjusting frequency as it rises.
Set the cycle by watching pigs. If the floor is soaked after the cycle, shorten the on time or lengthen the off time. If pigs still pant and spread out, increase frequency or add air speed. Install pressure regulators and filters so nozzles deliver uniform flow, and plan for water supply capacity during the hottest hours. See Ventilation Rate Calculations: Tunnel vs. Sidewall for airflow design.
Other cooling options
- Wallows and shower pads in outdoor systems, as in Wallowing Behavior: Providing Effective Wallows.
- Shade and roof insulation, which cut solar load.
- Cool cells, which cool incoming air in tunnel barns.
- Snout coolers and ground-water cooling for sows in farrowing, which target the animal rather than the room.
- Feeding strategy: shifting feed to cooler hours and adjusting diets, see Seasonal Diet Adjustments: Summer vs. Winter Formulations.
Reducing stocking density in hot weather also lowers heat load, and selecting for heat tolerance may help in the long run, see Heat Tolerance Genetics: Selecting for Tropical Climates.
Monitoring pigs and the barn
Watch for panting, spreading out, wet pigs on slats, reduced feed intake and lying in manure. Check pigs at the hottest part of the day. A thermometer at pig level and humidity sensors show real conditions, which often differ from the controller reading. Track daily water intake and mortality.
Heavy pigs, lactating sows and recently moved animals are at greatest risk. Avoid handling and transport during the hottest hours. Prepare for heat waves with backup generators, water supply and emergency plans, covered in Emergency Ventilation: Backup Power and Alarms.
Maintenance checklist
- Flush lines and clean filters at the start of the season.
- Test nozzles or drippers for flow and uniformity.
- Check timers and sensors for accuracy.
- Inspect fans, inlets and cool cells.
- Fix leaks, which waste water and wet floors.
Mineral buildup from hard water reduces performance, and descaling may be needed. Replace worn parts, since uniform delivery is essential.
Choosing between them
Choose drip when your barn has slatted floors, tunnel ventilation and a humid climate, since it cools with less added humidity. Choose misting or fogging when you have open-sided buildings, dry air and good airflow, or when you need broad cooling outdoors. In many barns, a combination works, with drip for lying pigs and fog or cool cells for the air.
Test any system in one pen first and measure effect on feed intake, growth and floor conditions. Check energy and water costs, and talk to your extension specialist about local experience.
FAQ
Which is better for pigs, drip or misting?
Drip generally adds less humidity and suits tunnel-ventilated slatted barns, while misting works best in dry climates with strong airflow, so the right choice depends on your building and climate.
Can I run misters constantly?
No, constant misting can soak floors and raise humidity, which reduces cooling and increases ammonia, so use timers and temperature control with dry periods.
Does cooling help even if pigs look comfortable?
Often yes, because feed intake and performance can drop before obvious heat signs appear, so use temperature and pig behavior to set your cooling triggers.