SwineFarming.org

Home › Articles › Swine Housing Deep Dives › Heat Mat vs. Heat Lamp for Piglets: Energy and Welfare

Swine Housing Deep Dives

Heat Mat vs. Heat Lamp for Piglets: Energy and Welfare

Newborn piglets are born wet, with little body fat and poor ability to regulate temperature, so supplemental heat in the farrowing room is essential. The two common choices are the heat lamp and the heated floor mat or pad. They differ in energy use, fire risk, piglet behavior and cost. This article compares them, explains what temperatures piglets need at different ages, and shows how to place and manage each so piglets stay out of the sow's way. Use the figures as typical ranges and follow manufacturer instructions and your veterinarian's advice for your herd.

Why piglets need extra heat

A sow is most comfortable in a room around the low 60s to low 70s degrees Fahrenheit, while a newborn piglet needs a lying area near 90 to 95 degrees Fahrenheit in the first days. The gap is large. Piglets that get cold burn energy, move slowly to the udder, get less colostrum and are more likely to be crushed. See Sow Colostrum Quality: Nutritional Interventions for why early intake matters.

Supplemental heat is therefore a small, local warm zone inside a cooler room, not heating of the whole room to piglet temperature.

How heat lamps work

Heat lamps radiate infrared heat from a suspended bulb, commonly around 250 watts, warming piglets and surfaces beneath it. They are cheap to buy, simple to hang and can be raised or lowered to adjust intensity.

Weaknesses include high electrical use per litter, bulbs that burn out unnoticed, uneven heat and, most seriously, fire risk. Dust, cobwebs and bedding near hot bulbs have started barn fires, covered in Fire Safety in Swine Barns: Prevention and Response. Lamps also can make piglets hot on the top and cool underneath, because the floor is not warmed.

How heat mats and pads work

A heated mat or pad warms the surface the piglets lie on, using low-wattage electric elements or circulated warm water. Piglets lie on the warm surface and pull heat by contact, which reduces the need to heat the air above.

Mats typically use far less power than a heat lamp, run at a regulated surface temperature, have lower fire risk and give more even warmth. The capital cost is higher, and mats need regular cleaning and inspection for damage or chewing. Water-heated systems require a boiler and plumbing.

Energy and cost comparison

FactorHeat lampHeat mat
Typical power per litterHigherLower
Purchase costLowHigher
Fire riskHigherLower
Even heatingLess evenMore even
MaintenanceBulb replacementCleaning, inspection

Electricity savings from mats can repay the higher purchase cost over a few years in busy farrowing rooms, but results depend on local power prices, room temperature and utilization. Calculate by multiplying power draw by hours and rate for your farm.

Piglet behavior and welfare

Watch the litter. Piglets huddled tightly under or on the heat source and shivering are cold. Piglets sprawled away from the heat and panting are too hot. A comfortable litter lies in a relaxed group near the edge of the warm zone and moves in and out.

Mats encourage piglets to lie away from the sow, reducing crushing risk. Lamps can do the same when placed in a creep area away from the sow. For design, see Free-Farrowing Pens: Design and Piglet Survival and Farrowing Welfare: Confinement vs. Free. Heat that is too hot, especially a bare lamp near young piglets, can burn skin, so keep it at the right height.

Placement and setup

Good setup includes:

  1. Place heat in a creep area where the sow cannot easily lie.
  2. Give the whole litter enough warm area to lie together.
  3. Lower the temperature as piglets grow, for example gradually down to the high 70s or 80s by weaning-age, depending on room conditions.
  4. Provide a draft-free cover or a creep lid to hold in heat.
  5. Keep cords, plugs and heating elements out of reach of piglets and sows.

Use a thermometer at piglet level rather than guessing from the room reading.

Safety and maintenance

For lamps, use guards and secure fixtures, clean dust regularly, never hang lamps by the cord and replace damaged sockets. For mats, check for cracks, exposed wires and chewing, and follow washing instructions. Use ground-fault protected circuits in damp rooms and have a qualified electrician inspect wiring. A fire in a farrowing room can kill many animals within minutes, so prevention is not optional.

Keep records of heater failures and ask staff to check heat sources at each round.

Choosing for your farm

Heat mats suit new or renovated farrowing rooms where energy and fire risk matter and where capital is available. Heat lamps may remain practical in low-capital or small operations if managed carefully, or as a backup. Some farms use mats with a lamp for the first day or two. Combined with good ventilation and drafts control, as in Ventilation Rate Calculations: Tunnel vs. Sidewall, either can work. Confirm electrical and building code requirements locally.

FAQ

What temperature should the piglet creep area be?

Roughly 90 to 95 degrees Fahrenheit at piglet level in the first days, reduced gradually as piglets grow. Watch piglet behavior to fine tune.

Are heat mats safer than heat lamps?

Generally yes, because they run at lower power and surface temperature and carry less fire risk, though they still require proper electrical installation and inspection.

Do heat mats save energy?

Usually, since they warm the piglets directly rather than the air, but actual savings depend on your electricity cost and how well the room is insulated.

Keep learning

Browse all 700 guides →