Deep intrauterine insemination places semen further along the sow's reproductive tract than conventional cervical AI. In practice it usually means post-cervical insemination, where a thin inner catheter passes through the cervix and deposits the dose in the uterine body, and, less commonly, true deep insemination into the uterine horn. The aim is to get good fertility from a much smaller number of sperm, which stretches the output of top boars. This article explains the technique, the equipment, the results to expect, and the practical limits.
How it differs from conventional AI
In conventional AI, a catheter is locked into the cervix and a dose of about three billion sperm in 80 to 100 milliliters flows into the cervix and uterus. In post-cervical insemination, a flexible inner cannula is passed through the outer catheter and past the cervix, placing a smaller volume of semen into the uterine body. In deep insemination, a longer flexible catheter reaches farther toward the utero-tubal junction. Because less sperm is lost to backflow and cervical transport, fewer sperm are needed per dose.
Why producers use it
- More doses per boar: a typical post-cervical dose may use roughly half or less of the sperm in a conventional dose, so genetic gains from top boars reach more sows.
- Reduced boar numbers: fewer boars may be needed to serve the same herd.
- Use of costly semen: high-value genetics, or sexed semen where applicable; see sexed semen in swine.
- Faster dosing: the volume is smaller so it can take less time.
Costs of semen, stud housing and boar replacement are a big part of AI economics, so efficiency matters.
Equipment and technique
Post-cervical catheters have an outer tube that seats in the cervix and an inner tube that extends beyond it. The process generally runs as follows:
- Clean the vulva and check that the sow is in standing heat with a boar present.
- Insert the outer catheter in the usual way and lock it in the cervix.
- Pass the inner cannula gently through the outer tube until it moves past the cervix, without force.
- Attach the semen container and allow the dose to flow in slowly over a few minutes.
- Remove the inner cannula, then the outer, and record the service.
Use only equipment designed for the purpose, keep everything clean and follow the product's instructions and your veterinarian's advice.
Results and what research suggests
Field experience and trials generally show that post-cervical insemination can achieve similar farrowing rate and litter size with a reduced sperm number, when done correctly and with good-quality semen. Results are not guaranteed. Outcomes depend on semen quality, timing, technique and the sow, and a poorly done procedure can reduce fertility. Gilts are more difficult, since the cervix is narrower and may be harder to pass. Compare results on your own farm using farrowing rate benchmarks.
Timing and semen requirements
With fewer sperm per dose, the timing of insemination matters more, since fewer sperm remain to wait for ovulation; see AI timing. Semen quality must be high and fresh, with good motility and morphology; see semen quality analysis and semen storage. Fixed-time programs sometimes pair with post-cervical dosing; see fixed-time AI.
Welfare and safety
Done gently, the procedure should not hurt the sow, but rough technique can damage the cervix or uterus and cause infection. Staff must be trained, nails kept short, hands clean, and sows restrained calmly. Never force the inner catheter. If resistance is felt, stop and retry with a standard cervical dose. Sows with reproductive tract problems should not be bred deep. Bleeding after insemination is a sign to review technique. Keep sows calm during and after the procedure.
Common mistakes
- Using poorly stored or old semen with a reduced dose.
- Breeding too early or too late relative to ovulation.
- Forcing the inner catheter through a tight cervix.
- Skipping boar stimulation so the sow is not relaxed.
- Ignoring cleaning between sows.
- Applying the method to gilts without training.
Is it right for your farm?
Consider it when semen costs or boar numbers are limiting, when you have trained staff and when you can track results. A small farm with few sows and cheap boars may not gain much. Run a trial on part of the herd, then compare farrowing rate and total born before adopting widely. For overall AI practice see artificial insemination in swine.
Training and quality control for technicians
Technique is the main source of variation. Introduce post-cervical dosing with hands-on training from an experienced technician or supplier, start with multiparous sows that show a strong standing response, and move to harder animals only when the crew is confident. Record the technician for every service so you can compare farrowing rate and litter size by person. If one technician's results lag, observe the method rather than assume the cause: common problems include rushing the dose, poor boar stimulation and incomplete seating of the outer catheter. Re-check results after each change. Many herds also keep a few conventional doses available so that a sow with a tight cervix can be bred normally instead of forced.
FAQ
Does post-cervical AI lower fertility?
Not when done correctly with good semen and timing. Results vary, so monitor your own farrowing rate.
Can I use it on gilts?
It is more difficult in gilts and not always recommended; many herds use conventional AI for them.
How much semen does it save?
Often around half of the conventional sperm number or less, but follow your supplier's dose guidance.