In a herd where several boars run with a group of sows, or where sows are inseminated with semen from different boars in the same cycle, the sire of a litter is often uncertain. Wrong pedigrees spoil genetic evaluation, because the performance of a pig is credited to the wrong parent. DNA parentage verification solves the problem by matching offspring to their parents using genetic markers. This article explains how the testing works, when it is worth the cost, how to collect samples and how to use results for better breeding decisions.
Why accurate pedigree matters
Genetic evaluation relies on knowing who is related to whom. If a boar is credited with progeny he did not sire, his estimated breeding value is distorted and the real sire's value is diluted. Errors also cause wrong decisions about inbreeding, since mistakenly mated relatives could occur. Pedigree error rates in livestock are often several percent or higher in multi-sire and group systems, though they vary widely. Even small error rates reduce genetic progress. See Genetic Evaluation Models: BLUP vs. Single-Step.
Where errors come from
- Multi-sire matings, where several boars serve the same group or sows.
- AI mix-ups, such as wrong semen dose or two doses from different boars.
- Delayed returns to service and mating at the wrong cycle.
- Cross-fostering, which can mislead if the dam is recorded as the nursing sow, see Crossfostering Strategies: Timing and Limits.
- Tag loss and mislabeling of piglets.
- Recording errors on cards and in software.
How DNA testing works
Laboratories genotype a panel of markers, either microsatellites or, more commonly now, SNPs, in each piglet and in candidate parents. Each piglet inherits one copy of each marker from each parent. If a candidate sire has no matching allele with the piglet at several markers, he is excluded. A panel of 100 or so well-chosen SNPs is usually sufficient to determine parentage in a given breed, though the number needed depends on how closely related the candidates are. See SNP Chips for Swine: Density and Application.
When it is worth doing
Parentage testing pays most in nucleus and multiplication herds where selection decisions depend on pedigree, and in stud programs that sell breeding stock. It is also useful for show pig breeders marketing registered animals, and for herds using group natural mating to save labor. In commercial herds that do not select replacements from their own stock, it is usually unnecessary. Compare test cost with the value of avoided mistakes and the cost of lost genetic progress.
Collecting and handling samples
- Identify each piglet and parent with a unique tag.
- Collect tissue at processing, for example from an ear notch, into a barcoded tube.
- Clean the notcher between animals to avoid contamination.
- Keep a log linking tag, barcode and litter.
- Store samples as instructed by the laboratory, often dry or in alcohol.
- Collect samples from all candidate sires, and also from dams.
Poor sample handling is a common reason for failed tests. A mix-up at this stage produces errors worse than none.
Interpreting results
The laboratory reports whether each candidate sire is assigned or excluded for each piglet, with a confidence figure. When two candidates remain, because the boars are close relatives, further markers may be tested. Mismatches with the recorded dam may reveal swaps or fostering problems. Update the pedigree with verified information and keep a record of the corrections. If error rates are high, review procedures rather than merely correcting records.
Reducing the need for testing
Good management reduces errors: use single-sire mating groups where possible, record services carefully, record AI doses and boars, and tag piglets within a day or two. Using one boar per sow group or per week also allows a pedigree to be approximated by management. For valuable pedigrees, apply testing to a sample and see if the error rate justifies full testing. See Record Keeping Systems: Software Comparison and Boar Fertility Testing: Minimum Standards for AI Centers.
Costs, turnaround and practical tips
Test costs per sample have fallen as genotyping volumes have grown, and many breeding companies include parentage in their genomic programs. Ask laboratories about price per animal, the turnaround time, the number of markers used and what is included in the report. Turnaround matters if you need to choose breeding stock before a deadline, so send samples in time. Test selection candidates first rather than the whole litter, and add further animals if error rates are high. Keep the original results with the animal's record, and update the herd software so later evaluations use the corrected pedigree. Where only a few boars are in play, testing a sample of litters each year can monitor error rates cheaply.
FAQ
How accurate is DNA parentage testing?
When done with an adequate marker panel and good samples, it is highly accurate and very high for exclusion.
Do I have to test every piglet?
No, many programs test only selection candidates or those with uncertain sires.
Can testing find mix-ups with the dam?
Yes, since dam and offspring genotypes should match, errors from fostering or labeling can be detected.